HOTLINE
0909648899 028 62578355
Thiết bị chuyển mạch Công nghiệp Planet IGS-6325-8UP2S
| Model | IGS-6325-8UP2S |
|---|---|
| Hardware Specifications | |
| Copper Ports | 8 x 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports |
| SFP Ports | 2 x 1000BASE-SX/LX/BX SFP slot interfaces (Port-9 and Port-10) Compatible with 100BASE-FX and 2500BASE-X SFP |
| PoE Injector Port | 8 ports with 802.3bt PoE++ injector function with Port-1 to Port-8 |
| Console | 1 x RJ45-to-RS232 serial port (115200, 8, N, 1) |
| Switch Architecture | Store-and-Foward |
| Switch Fabric | 20 Gbps/non-blocking |
| Throughput (packet per second) | 14.8Mpps@ 64 bytes packet |
| Address Table | 16K entries, automatic source address learning and aging |
| Shared Data Buffer | 32 Mbits |
| Jumbo Frame | 10Kbytes |
| SDRAM | 512Mbytes |
| Flash Memory | 64Mbytes |
| Flow Control | IEEE 802.3x pause frame for full duplex Back pressure for half duplex |
| Reset Button | < 5 sec: System reboot > 5 sec: Factory default |
| Connector | Removable 6-pin terminal block for power input - Pin 1/2 for Power 1, Pin 3/4 for fault alarm, Pin 5/6 for Power 2 Removable 6-pin terminal block for DI/DO interface - Pin 1/2 for DI 1 & 2, Pin 3/4 for DO 1 & 2, Pin 5/6 for GND |
| Alarm | One relay output for power failure. Alarm relay current carry ability: 1A @ 24V DC |
| Digital Input (DI) | 2 digital input: - Level 0: -24~2.1V (±0.1V) - Level 1: 2.1~24V (±0.1V) - Input load to 24V DC, 10mA max. |
| Digital Output (DO) | 2 digital output: - Open collector to 24VDC, 100mA |
| Enclosure | IP30 aluminum case |
| Installation | DIN-rail kit or wall mounting |
| Dimensions (W x D x H) | 76.8 x 107.3 x 152 mm |
| Weight | 1138g |
| Power Requirements | Dual DC 48~56V, 7.5A max. (>52V DC for 802.3bt PoE++ output recommended) |
| Power Consumption | Max. 27 watts/92.13BTU@56V DC input (System on) Max. 395 watts/1,347.80BTU@56V DC input (Full loading with 802.3bt PoE++ function) |
| ESD Protection | Air 8KV DC Contact 6KV DC |
| Surge Protection | 4KV DC |
| Power over Ethernet | |
| PoE Standard | IEEE 802.3bt PoE++ Type-4 PSE Backward compatible with 802.3at PoE+ PSE |
| PoE Power Supply Type | ■ 802.3bt ■ UPOE/POH ■ End-span ■ Mid-span ■ Force |
| PoE Power Output | 802.3bt PoE++ - Per port 52V~56V DC (depending on the power supply), max. 90 watts UPoE(PoH) - Per port 52V~56V DC (depending on the power supply), max. 95 watts IEEE 802.3at Standard - Per port 52V~56V DC (depending on the power supply), max. 36 watts Force - Per port 52V~56V DC (depending on the power supply), max. 60 watts |
| Power Pin Assignment | End-span: 1/2(-), 3/6(+) Mid-span: 4/5(+), 7/8(-) 802.3bt/UPoE: 1/2(-), 3/6(+),4/5(+), 7/8(-) |
| PoE Power Budget | 360W maximum (depending on power input) |
| Environments | |
| Operating Temperature | -40 ~ 75 degrees C |
| Storage Temperature | -40 ~ 85 degrees C |
| Humidity | 5 ~ 95% (non-condensing) |
| Data sheet Planet IGS-6325-8UP2S | ||
|---|---|---|
 |
||
| PoE Management Functions | ||
| Active PoE device alive detects | ✔ | |
| PoE Power Recycle | ✔ - daily or predeinded schedule | |
| PoE Schedule | 4 schedule profiles | |
| PoE Extend Mode | ✔ - max. 160 to 200 meters | |
| PoE System Management | System PoE Admin control Total PoE power budget control Auto power input and PoE budget control PoE Legacy mode Over-termperature threshold alarm PoE usage threshold alarm |
|
| PoE Port Management | Port Enable/Disable/Schedule PoE mode control - 802.3bt - UPoE - 802.3at End-span - 802.3at Mid-span Force mode Port Priority |
|
| Layer 3 Functions | ||
| IP Interfaces | Max. 128 VLAN interfaces | |
| Routing Table | Max. 128 routing entries | |
| Routing Protocols | IPv4 hardware static routing IPv6 hardware static routing IPv4 OSPFv2 dynamic routing |
|
| Layer 2 Functions | ||
| Port Configuration | Port disable/enable Auto-negotiation 10/100/1000Mbps full and half duplex mode selection Flow control disable/enable Port link capability control |
|
| Port Status | Display each port’s speed duplex mode, link status, flow control status, auto negotiation status, trunk status | |
| Port Mirroring | TX / RX / both Many-to-1 monitor |
|
| VLAN | 802.1Q tagged VLAN Q-in-Q tunneling Private VLAN Edge (PVE) MAC-based VLAN Protocol-based VLAN Voice VLAN MVR (Multicast VLAN Registration) GVRP Up to 256 VLAN groups, out of 4095 VLAN IDs |
|
| Link Aggregation | IEEE 802.3ad LACP/Static Trunk Supports 3 trunk group with 4 ports per trunk group |
|
| Spanning Tree Protocol | IEEE 802.1D Spanning Tree Protocol IEEE 802.1w Rapid Spanning Tree Protocol IEEE 802.1s Multiple Spanning Tree Protocol |
|
| IGMP Snooping | IPv4 IGMP (v1/v2/v3) snooping IPv4 IGMP querier mode support Supports 255 IGMP groups |
|
| MLD Snooping | IPv6 MLD (v1/v2) snooping, IPv6 MLD querier mode support Supports 255 MLD groups |
|
| Access Control List | IP-based ACL/MAC-based ACL ACL based on: - MAC Address - IP Address - Ethertype - Protocol Type - VLAN ID - DSCP - 802.1p Priority Up to 256 entries |
|
| Bandwidth Control | Per port bandwidth control - Ingress: 500Kbps~1000Mbps - Egress: 500Kbps~1000Mbps |
|
| QoS | Traffic classification based, strict priority and WRR 8-level priority for switching - Port number - 802.1p priority - 802.1Q VLAN tag - DSCP/TOS field in IP packet |
|
| Synchronization | IEEE 1588v2 PTP(Precision Time Protocol) - Peer-to-peer transparent clock - End-to-end transparent clock |
|
| Management | ||
| Basic Management Interfaces | Console; Telnet; Web browser; SNMP v1, v2c | |
| Secure Management Interfaces | SSHv1/SSHv2, TLS, SSL, SNMP v3 | |
| System Management | Firmware upgrade by HTTP protocol through Ethernet network Configuration upload/download through HTTP Remote Syslog System log LLDP protocol NTP PLANET Smart Discovery Utility |
|
| Standards Conformance | ||
| Regulatory Compliance | FCC Part 15 Class A CE: EN55032, EN55035 |
|
| Stability Testing | IEC60068-2-32 (free fall) IEC60068-2-27 (shock) IEC60068-2-6 (vibration) |
|
Planet WGS-4215-8HP2S : Industrial 4-Port 10/100/1000T 802.3bt...
Liên hệ để có giá tốt
Liên hệ để có giá tốt
Liên hệ để có giá tốt
