Planet WGS-5225-8UP2SV : Industrial L2+ 8-Port 10/100/1000T 802.3bt PoE + 2-Port 100/1000X SFP Wall-mount Managed Switch with LCD Touch Screen
Thiết bị chuyển mạch Công nghiệp Planet WGS-5225-8UP2SV
Model | WGS-5225-8UP2SV |
---|---|
Hardware Specifications | |
Copper Ports | 8 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports |
SFP Slots | 2 100/1000/2500BASE-X SFP interfaces Compatible with 100BASE-FX, 1000BASE-SX/LX/BX and 2500BASE-X SFP transceivers |
PoE Injector Port | 8 ports with 802.3bt PoE++ injector function with Port-1 to Port-8 |
RAM | 128MBytes |
Flash Memory | 64MBytes |
Reset | < 5 sec: System reboot > 5 sec: Factory default |
Connector | 4-pin terminal block for power input - Pin 1/2 for Power 1 (Pin 1: V+ / Pin 2: V-) - Pin 3/4 for Power 2 (Pin 3: V+ / Pin 4: V-) 2-pin terminal block for event alarm |
Alarm | One relay output for power failure. Alarm Relay current carry ability: 1A @ 24V DC |
Enclosure | IP30 aluminum case |
Installation | Wall-mount |
Dimensions (W x D x H) | 245 x 36 x 140 mm |
Weight | 1,299g |
Power Requirements | 48~54V DC (>52V DC for PoE++ and PoE+ output recommended) Dual power input is required for maximum power loading |
Power Consumption | Max. 14.72 watts/50.23 7BTU@50V DC input (Power on without any connection) Max. 375 watts/1280BTU@Single 54V DC input (Full loading with 360 watts PoE function) Max. 752 watts/2566BTU@Dual 54V DC input (Full loading with 720 watts PoE function) |
ESD Protection | 6KV DC |
Switching Specifications | |
Switch Architecture | Store-and-Foward |
Switch Fabric | 26Gbps/non-blocking |
Throughput (packet per second) | 19.345Mpps@ 64 bytes packet |
Address Table | 8K entries, automatic source address learning and aging |
Shared Data Buffer | 4Mbits |
Flow Control | IEEE 802.3x pause frame for full duplex Back pressure for half duplex |
Jumbo Frame | 9Kbytes |
Power over Ethernet | |
PoE Standard | IEEE 802.3bt PoE++ Type-4 PSE Backward compatible with 802.3at PoE+ PSE |
PoE Power Supply Type | - 802.3bt - UPOE/POH - End-span - Mid-span - Force |
PoE Power Output | 802.3bt PoE++ - Per port 52V~56V DC (depending on the power supply), max. 90 watts UPoE(PoH) - Per port 52V~56V DC (depending on the power supply), max. 95 watts IEEE 802.3at Standard - Per port 52V~56V DC (depending on the power supply), max. 36 watts Force - Per port 52V~56V DC (depending on the power supply), max. 60 watts |
Power Pin Assignment | End-span: 1/2 (-), 3/6 (+) Mid-span: 4/5 (+), 7/8 (-) 802.3bt/UPoE: 1/2 (-), 3/6 (+),4/5 (+), 7/8 (-) |
PoE Power Budget | 48V Power input - 125W maximum (depending on power input) 52~54V Power input - Single power input: 360W maximum (depending on power input) - Dual power input: 720W maximum (depending on power input) ※Dual power input must be the same as DC voltage, like dual 54V |
Stadards & Environments | |
Operating Temperature | -20 ~ 70 degrees C |
Storage Temperature | -40 ~ 85 degrees C |
Humidity | 5 ~ 95% (non-condensing) |
Regulatory Compliance | FCC Part 15 Class A, CE |
Stability Testing | IEC60068-2-32 (free fall) IEC60068-2-27 (shock) IEC60068-2-6 (vibration) |
Data sheet Planet WGS-5225-8UP2SV
WGS-5225-8UP2SV Industrial L2+ 8-Port 10/100/1000T 802.3bt PoE + 2-Port 100/1000X SFP Wall-mount Managed Switch with LCD Touch Screen |
||
---|---|---|
PoE Management Functions
|
||
Active PoE device alive detects | Yes | |
PoE Power Recycle | Yes, daily or predeinded schedule | |
PoE Schedule | 4 schedule profiles | |
PoE Extend Mode | Yes, max. 160 to 200 meters | |
PoE System Management | System PoE Admin control Total PoE power budget control Auto power input and PoE budget control PoE Legacy mode Over-temperature threshold alarm PoE usage threshold alarm |
|
PoE Port Management | Port Enable/Disable/Schedule PoE mode control - 802.3bt - UPoE - 802.3at End-span - 802.3at Mid-span - Force mode Port Priority |
|
Layer 3 Functions | ||
IP Interfaces | Max. 8 VLAN interfaces | |
Routing Table | Max. 32 routing entries | |
Routing Protocols | IPv4 hardware static routing IPv6 hardware static routing |
|
Layer 2 Functions | ||
Port Configuration | Port disable/enable Auto-negotiation 10/100/1000Mbps full and half duplex mode selection Flow control disable/enable Port link capability control |
|
Port Status | Display each port’s speed duplex mode, link status, flow control status, auto negotiation status, trunk status | |
Port Mirroring | TX/RX/Both Many-to-1 monitor |
|
VLAN | IEEE 802.1Q tag-based VLAN IEEE 802.1ad Q-in-Q tunneling Private VLAN Edge (PVE) MAC-based VLAN Protocol-based VLAN Voice VLAN MVR (Multicast VLAN Registration) GVRP Up to 4K VLAN groups, out of 4094 VLAN IDs |
|
Link Aggregation | IEEE 802.3ad LACP/static trunk Supports 2 trunk groups with 2 ports per trunk group |
|
Spanning Tree Protocol | IEEE 802.1D Spanning Tree Protocol (STP) IEEE 802.1w Rapid Spanning Tree Protocol (RSTP) IEEE 802.1s Multiple Spanning Tree Protocol (MSTP) |
|
IGMP Snooping | IPv4 IGMP (v1/v2/v3) snooping IPv4 IGMP Querier mode support Supports 255 IGMP Groups |
|
MLD Snooping | IPv6 MLD (v1/v2) snooping, IPv6 MLD Querier mode support Supports 255 muticast Groups |
|
Bandwidth Control | Per port bandwidth control - Ingress: 500Kb~1000Mbps - Egress: 500Kb~1000Mbps |
|
RING | Supports ERPS, and complies with ITU-T G.8032 Recovery time < 10ms |
|
Synchronization | IEEE 1588v2 PTP (Precision Time Protocol) - Peer-to-peer transparent clock - End-to-end transparent clock |
|
QoS | Traffic classification based, strict priority and WRR 8-level priority for switching - Port number - 802.1p priority - 802.1Q VLAN tag - DSCP/TOS field in IP packet |
|
Security Functions | ||
Access Control List | IP-based ACL/MAC-based ACL ACL based on: - MAC Address - IP Address - Ethertype - Protocol Type - VLAN ID - DSCP - 802.1p Priority Up to 256 entries |
|
Security | Port security IP source guard Dynamic ARP inspection Command line authority control based on user level |
|
AAA | RADIUS client TACACS+ client |
|
Network Access Control | IEEE 802.1x port-based network access control MAC-based authentication Local/RADIUS authentication |
|
Management Functions | ||
Basic Management Interfaces | Telnet; Web browser; SNMP v1, v2c | |
Secure Management Interfaces | SSHv2, TLS v1.2, SNMPv3 | |
System Management | Firmware upgrade by HTTP protocol through Ethernet network Configuration upload/download through HTTP LLDP protocol NTP PLANET Smart Discovery Utility |
|
Event Management | Remote Syslog System log SMT |
|
ONVIF | ONVIF device discovery ONVIF device monitoring Floor Map |
Liên hệ để có giá tốt
Liên hệ để có giá tốt
Liên hệ để có giá tốt